MATERIAL FIRST. POSSIBILITY NEXT.
Find an offcut for your next order.
Give good material a second job, with a cutting plan that fits.
Your order
Non-structural use
Pieces to make
2 piecesAllow a small size adjustment
Only inside the minimum sizes above.
One rectangular offcut per order. Whole-millimetre adjustments, up to 20 mm per dimension.
02 / YOUR MATERIAL MATCH
Canal Street Joinery
Marrickville · 2.4 km pickup estimate Sample listing
Loading saved workshop…
Seller, pickup & disposal baseline
- Workshop
- Canal Street Joinery · Marrickville
- Condition notes
- No defect notes recorded. Inspect the material before cutting.
- Pickup
- Agree a pickup time with the seller.
- Contact
- Use the reservation conversation to arrange collection.
- Alternative destination
- Unknown / not establishedNo evidence recorded.
These seller details and baseline are fictional sample data.
Final pieces, remaining material & cut sequence
| Piece | Requested | Final size | Orientation |
|---|---|---|---|
| A1 · Display panel | 400 × 400 | 398 × 400 mm | Grain aligned |
| A2 · Display panel | 400 × 400 | 398 × 400 mm | Grain aligned |
Remaining rectangles: 800 × 47 mm. Inspect before reuse. These are planned remnants until cutting is completed.
Blade loss: 0.004 m² · edge allowance: 0.000 m². All areas reconcile to 0.360 m².
- Cut 1: horizontal, 400 mm from the original top edge; segment starts at (0, 400) mm and spans 800 mm.
- Cut 2: vertical, 398 mm from the original left edge; segment starts at (398, 0) mm and spans 400 mm.
- Cut 3: vertical, 799 mm from the original left edge; segment starts at (799, 0) mm and spans 400 mm.
Blade width is measured on the waste side of each piece boundary. Edge cuts may extend beyond the remaining material. Check the machine setup before cutting.
Compare available offcuts 3 matches
Matching stock, ordered by listed price.